New AccuLock S Power Pins for Miller Equipment

August 20, 2019

Effective immediately, a new, enhanced AccuLock™ S power pin is now available for Miller® equipment. This new power pin is designed specifically for use with the new Bernard® AccuLock S consumable system to optimize performance.

AccuLock S Power Pin for Miller
CONVENTIONAL (Shown Left) Miller® Power Pin Design
If your power pin has a large ID, please contact Customer Service to get the new AccuLock S Power Pin.

NEW (Shown Right) AccuLock S Power Pin Design
Torque to 10 ft-lbs / 120 in-lbs (13.5 Nm)

Affected Part Numbers

2200137Has been replaced by 2200206 and 2200207 in the AccuLock S consumables system as noted directly following
2200206Replaces 2200137 for wire sizes 0.023″ (0.6 mm) – 5/64″ (2.0 mm)
2200207Replaces 2200137 for wire sizes 3/32″ (2.4 mm) – 1/8″ (3.2 mm)

AccuLock S Consumables

Load and Lock for Better Productivity

  • Reduce welding troubleshooting, downtime and rework
  • Flawless wire-feed pathAccuLock S liners are locked and concentrically aligned to both the contact tip and the power pin without the use of fasteners
  • Error-proof liner replacement every time – no measuring required.
  • Simplify MIG welding inventory with a common consumable platform

Learn more about AccuLock S consumables.