How To Install an Aluminum Liner on TOUGH GUN Robotic MIG Guns Equipped with Wire Brake


STEP 1:

  • Insert the bronze jump liner (part #495-18-25) into the neck.
  • Position the liner stop flush with the back of the power pin.
  • Cut the liner 1/2 inch from the consumable side of the neck.

STEP 2:

  • Insert the Teflon liner into the torch until it stops.
  • Measure from the end of the power pin to the liner retainer and record the measurement.
  • Remove the Teflon liner.

STEP 3:

  • Use the recorded measurement to mark the distance from the end of the liner to the cut point.
  • Cut the liner.
  • Reinstall the liner.

INS042 REV 06/04