Products
Documentation
Articles

How to repair the cable on a MIG Gun with a T Series Straight Handle

How to Repair the Cable on a BTB MIG Gun with a T Series Straight Handle Remove consumables (Nozzle, Retaining Head, Contact Tip). Remove the liner from the gun. Mount neck in the vise. Disassemble handle and remove switch from leads. Move the handle back. Bend cable behind connector cone. Cut cable at bend. Slide […]

read more...

How To Install or Replace a Euro Power Pin on a BTB Platform Gun

How To Install or Replace a Euro Power Pin on a BTB Platform Gun Remove liner and strain relief from the gun assembly. Disconnect the Euro block leads from the gun by cutting as close as possible on both sides of the butt connectors in order to preserve wire for later retermination. Slide adaptor nut […]

read more...

How To Install or Replace a Bernard Quick Disconnect on a BTB Platform Gun

How To Install or Replace a Bernard Quick Disconnect on a Best of the Best Platform MIG Gun  Remove liner from gun assembly. Viewing quick disconnect from cable end, align wave spring and large snap ring with opening access slot. Compress large snap ring with internal snap ring pliers and remove locking sleeve. Remove small […]

read more...

How To Install or Replace a Universal Power Pin on a BTB Platform Gun

How To Install or Replace a Bernard Power Pin on a BTB MIG Gun  Remove nozzle, contact tip, and gas diffuser / retaining head and lay cable straight. Using a 10 mm wrench, turn liner lock counterclockwise until it is free from the power pin. Remove liner from gun assembly.  Remove the screw and assembly […]

read more...