How To Install the TOUGH GUN Reamer TT Series


WARNING: Ensure the power supply is off and disconnected before proceeding!


Mounting the TOUGH GUN Reamer

  • The TOUGH GUN Reamer should be installed within the weld cell at a convenient location. Be sure to consider movable fixtures and the working envelope of the robot.
  • Affix the TOUGH GUN Reamer base to a sturdy platform using the four (4) bolts provided.

Mounting Hole Locations and Footprint

 

Connecting the Air Supply

WARNING: Push the RESET button before connecting the air line.

  • Use only filtered, lubricated air.
  • IMPORTANT: Requirements - 80 to 100 psi at 16 CFM (5.0 to 7.0 BAR at 450 LPM) at the TOUGH GUN Reamer during operation.
  • Use an air supply line with an inside diameter of 3/8 inches. Connect to a 1/4-inch female NPT inlet located on the side of the TOUGH GUN Reamer. 

Dimensions