Products
Documentation
Articles

Video | QUICK LOAD Liner AutoLength Introduction

QUICK LOAD™ Liner AutoLength™ Introduction Please accept preferences, statistics, marketing cookies to watch this video. Learn about the innovative QUICK LOAD Liner AutoLength from Tregaskiss. QUICK LOAD liner installs through the front of the MIG gun in less than half the time required to install a conventional liner. Increases production uptime, provides cost savings and […]

read more...

How to Replace QUICK LOAD Liners Into Retainer or AutoLength Pin

How to Replace QUICK LOAD Liners into Retainer or AutoLength Pin 1. Remove consumables (nozzle, contact tip and retaining head). 2. Pull the existing QUICK LOAD™ Liner from the neck using pliers. 3. Remove the protective cap from the new QUICK LOAD Liner. 4. Insert the QUICK LOAD Liner through the neck using the wire […]

read more...

How to Install QUICK LOAD Liners When Replacing Conventional Liners

How to Install QUICK LOAD Liners When Replacing Conventional Liners 1. Remove the protective cap from the new QUICK LOAD® Liner. 2. Install this liner from the back of the MIG gun with retainer attached (using the same procedure as installing a conventional liner). Future replacements will be done from the front. (Refer to How […]

read more...

How To Install a Jump Liner

How to Install or Replace a Jump Liner IMPORTANT! Turn off power. Remove nozzle, insulator, contact tip, gas diffuser and neck from gun. Remove old Jump Liner from the back end of the neck. Insert new Jump Liner making sure the liner stop is fully seated at back end of neck. Take the tapered end […]

read more...

How To Install Quik Tip Consumables

How to Install Quik Tip Consumables Standard Installation – Install insulator cap over neck. Trim liner to correct dimension for diffuser being used (see Liner Trim Guidelines). Torque diffuser onto neck to approximately 12 ft.-lbs. Insert tip into gas diffuser and lock into posiiton with a clockwise motion. Thread nozzle onto gas diffuser and tighten […]

read more...

How To Install Centerfire HD Series Consumables

How to Install Centerfire HD Series Consumables  Standard Installation – Install insulator cap over neck. Trim liner to between 5/8″ and 3/4″ beyond neck thread. Torque diffuser onto neck to approximately 12 ft.-lbs. Insert tip into gas diffuser. Thread nozzle body onto gas diffuser / tip, and tighten firmly by hand. Thread nozzle cone onto […]

read more...

How To Install Centerfire Consumables

How to Install Centerfire Consumables  Standard Installation – Install insulator cap over neck. Trim liner to between 5/8″ and 3/4″ beyond neck thread. Torque diffuser onto neck to approximately 12 ft.-lbs. Insert tip into gas diffuser. Thread nozzle onto gas diffuser / tip and tighten firmly by hand. Installation with Conversion Adaptor – Install conversion […]

read more...

How to Install or Replace a Liner When Using Centerfire or Quik Tip Diffusers With the New Internal Stop

How to Install or Replace a Liner When Using Centerfire or Quik Tip Diffusers With the NEW Internal Stop CAUTION: Disconnect gun from equipment, allow to cool and remove electrode from liner before servicing!   Diffuser Removal: Using the appropriate wrench, remove the gas diffuser with a counterclockwise rotation. Conventional Liner Installation: Re-insert liner into […]

read more...